Russound Collage Manual de instalación descargar pdf (Pagina 10)

10 Russound Collage System Installation Manual

Overview

As the home's electrical network is being used to transmit HomePlug

Power Line Carrier (PLC) signals, it is important to have the most robust

communication network possible. This is why intended installation

locations are pre-qualied BEFORE committing to a location and making

a hole in the wall.

Preparation

To perform binding and network verication you will need:

CAK1 keypad with pigtail (have all planned keypads on hand)•

CMM1 Media Manager and power cord•

Power strip•

Power up units

Plug all keypads into power strip. Each keypad's power supply 1.

should have a pigtail connected with a grounded three-prong plug,

and keypad should be assembled.

Plug the CMM1 Media Manager into the power strip. 2.

Wait for the keypads to boot up.3.

Naming the keypads

Each keypad should be named at this time. Give keypads unique 4.

names to avoid confusion when using the intercom or joining music

from another room. Write that name on a label and place it on the

aluminum frame of the keypad.

From the Initial Setup screen, choose Name, then use the wheel to 5.

scroll through the alphabet (upper and lower case), and press Select

to enter each letter. When nished, press Enter to save. Complete

the naming procedure for all keypads.

NAMING AND BINDING PROCEDURE

Binding the devices

The binding process associates the keypad with the media manager

(CMM1) by sharing a unique key and establishes communication and

identication of devices on the PLC network.

On the rst keypad, from the Initial Setup screen, scroll to and select 6.

Setup Gridcast Network.

Depress the binding button on the back of the CMM1. Wait for the 7.

LED to settle into a slow blinking mode (one second on/o) LED.

On the keypad, within 30 seconds scroll to and select Bind to Media 8.

Manager.

When the devices are bound to each other, the Status on the screen 9.

will change to Joined Network. Press Done to exit.

On the Initial Setup screen, press Done to complete the procedure.10.

Repeat the binding process for each additional keypad.11.

If there is an error or if the keypad shows "Waiting for others", power 12.

cycle the keypad and try again.

Once all keypads are bound to the Gridcast network, unplug all the

devices and proceed to location validation. Device names and binding

status are stored in memory and are not aected by power status.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comentarios a estos manuales

Sin comentarios

Russound Collage Manual de instalación Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta Russound Collage