Russound VM1 Video Matrix Manual de instalación descargar pdf (Pagina 13)

Russound VM1 Installation Manual

Rev. 1

No Hot Swap for VMR1

DO NOT UNPLUG VMR1 RECEIVERS WHILE VM1 AND TV ARE POWERED ON: The

power for the VMR1 receiver’s grounds through the television it is connected

to. The television’s video input can be damaged if the VMR1 receiver’s are “Hot

Swapped. “ Please insure that the television and the VM1 are powered o

before the VMR1 is connected or disconnected.

Troubleshooting Guide

PROBLEM CAUSE ACTION

Loss of picture / VM1 is

clicking

Bad power supply or wrong power supply is being used Check to insure that the A-PS power supply (24 volts) is connected. Test power

supply for 24 volts

Red (Pr) and Blue (Pb) colors

are reversed

RJ 45 connector is wired to T568B standard Rewire the RJ45 connector to the T568A standard

No picture Video Sync (Y) is carried on the Brown White / Brown Pair Check the Brown White / Brown Pair on the CAT-5 , Punch Down, and RJ45 connec-

tor

Red (Pr) is missing from the

picture

Red (Pr) is carried on the Orange White / Orange Pair Check the Orange White / Orange Pair on the CAT-5 , Punch Down, and RJ45 con-

nector

Blue (Pb) is missing from the

picture

Blue (Pb) is carried on the Green White/green Pair Check the Green White / Green Pair on the CAT-5 , Punch Down, and RJ45 connec-

tor

VMR1 receiver’s power

indicator is not lit

Power is carried on the Blue White/ Blue Pair Check the Blue White / Blue Pair on the CAT-5 , Punch Down, and RJ45 connector

Russound keypads are not

controlling the VM1

RNET communication is carried on the Blue Pair on the

RNET link.

Check the Blue White/ Blue Pair on the RNET cable and RJ45 connectors

No control of VM1 on Zones

7 & 8 / Keypads in zone 7 &

8 operate Zones 1& 2

Controller ID (on CAV/CAA/CAM) is set incorrectly Set controller ID on the controller to reflect controller 1, 2 , 3, etc.

Video sync issues for CAT-5e

runs less than 50 feet

VMR1 Receiver may require re-calibration Temporarily extend CAT-5e cable by 50 feet to see if problem is resolved. Try swap-

ping with a working VMR1 from another zone. Call Russound Dealer Support.

Color or picture stability

issues

DC voltage may be present on the video output signal of

the source, common on some cable/satellite boxes.

Use a DC blocker such as Audio Authority's Model 1183 Active Video DC Blocker.

For All VM1-4UC and VM1-8UC Users

Sources 1 and 4 and 5 and 8 are factory defaulted for composite video. To use

component or S-Video inputs, the internal switches must be changed. Please

refer to page 7 for this procedure.

For New VM1 Set-Up

A new VM1 outputs Source 1 video to all zones. When testing, turning the

system Party Mode on can help troubleshoot "no video" issues.

TROUBLESHOOTING GUIDE

1 2 ... 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Russound VM1 Video Matrix Manual de instalación Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Amplificadores de audio Russound VM1 Video Matrix