Russound COMPLEMENT SUB85 Manual de instrucciones descargar pdf (Pagina 7)

Line-level input

This input is for use when the receiver’s or processor’s

LFE or subwoofer output is turned off, or when the

receiver has no LFE or subwoofer output.

Connect a stereo RCA patch cable between the

SUB105’s line-level input jacks and the front left- and

right-channel line outputs on the receiver or processor.

Note: When the LFE or line-level input is connected

to an audio system powered by a different electri cal

circuit from the one used to power the SUB105, a

ground loop may result. This causes a low-frequency

hum. To eliminate the hum, connect the SUB105 to

the same electrical circuit as the audio system or use

a ground loop isolator in series with the RCA cable.

Connection using stereo line-level input

SUB105

Speaker Outputs

Line Level Output

Left Right

LFE Output

Stereo RCA

patch cable

Receiver

INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Russound COMPLEMENT SUB85 Manual de instrucciones Pagina 7